Wrapper

[Aaron'z 2.5RS/WRX]

Solder to it.. solder the wire flat to the terminal.. don't try poking anyting through..

Clean the terminal with acetone on a Q-tip, being careful of course..

MAKE SURE YOU MOVE FAST... use a hot (10-20min heating) iron, tin the terminal, quickly, let it cool.. lay the wire on, iron it, apply solder, melt, remove, cool by blowing or damp rag.... if it takes anymore than a few seconds, it's taking tooooo long..

this is where speed is of the essence.. the longer you take, the more heat will be soaking out into pastic and other parts..