Car Audio Forum
Car Audio Classifieds
Upgrade Your Account
Car Audio | DiyMobileAudio.com | Car Stereo Forum
How to make your own Remote Controller for Helix and Brax DSPs
View Single Post
on the soundstage should be exact and well focused...
Thanked 0 Times in 0 Posts
Re: How to make your own Remote Controller for Helix and Brax DSPs
Originally Posted by
Just a few questions;
Is any 10k linear potentiometer suitable?
Is any male to male micromatch connector (1.27 pitch) suitable?
Why are the pins for the P-DSP labelled right to left on your diagram, but left to right on the schematics?
1. Well, I think any "one turn", linear, 10k should be OK. I used carbon/graphite ones - just like for the usual volume control.
2. There's no "male to male" connector as the socket in the DSP is female. Any male 12 pin Micro Match will be ok. The only difference will be how you connect your wires to the plug. (ribbon / solder etc.)
3. It's dependant on the positioning of the socket on the DSP - as you can see the pin 12 is on the left in P-DSP and NOX4 but it's on the right in C-DSP. The pin 12 will always be on the side with the "gap".
View Public Profile
Send a private message to coobah
Find More Posts by coobah
All times are GMT -6. The time now is
-- DIY Mobile Audio
-- Mobile Skin
DIYMA.com - Car Audio Forum & 12 volt Community Board
Powered by vBulletin®
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
vBulletin Security provided by
vBSecurity v2.2.2 (Pro)
vBulletin Mods & Addons
Copyright © 2017 DragonByte Technologies Ltd.
Ad Management by
Back to top