Quote:
Originally Posted by sunshinefc3s View Post
My issue is the fraying of the power/ground wires. I'm a little OCD, and I hate when I cant get all the little strands of the power/ground back into the terminal cup of either the distribution/fuse block or the amp itself. Its worse after you remove it for service, and then try to reconnect. Gets messy. That is why I'm looking for a solution like above for larger Power cable.
-a
You could Torch solder the end of the wire, assuming you have room in the dist block.
Also get a dist block that offers larger size Wire do avoid some strands from not going in.
Get a ground block that takes ring terminals and not bare wire

Or check this thread for some tips that may help minimize the issue.

SET SCREW SOLUTION!!