Originally Posted by Alrojoca View Post
I searched a lot before choosing these over the XT60ís and the Deans.

The reason I did not choose the Deans, was that they need Heat shrink after soldering the wire and the part where the wire is soldered is small, no big deal, just a preference with more area and solder to use with the EC3ís, other issues I read about the Deanís, hard to disconnect and hard to work with.

Can you elaborate on this part? Are you talking about when you solder the lead(s) to the center pin ? Are you simply worried about that piece (or the shield portion) coming in contact with each other?