Car Audio Forum
Car Audio Classifieds
Upgrade Your Account
Car Audio | DiyMobileAudio.com | Car Stereo Forum
2009 Lexus RX 350 (2nd gen) door panel removal
View Single Post
Re: 2009 Lexus RX 350 (2nd gen) door panel removal
Phew. Now that has been done time to remove the seat belts bolts at the bottom of both passenger side & driver side in the back seat area. Pretty straight forward. This has to be removed in order to pry the plastic wheel well covers.
The wheel well covers are all pop rivets with the exception of the netting anchors that are in the middl of the wheel well and back of the cargo bay by the lift gate. These have to come off. So pop rivets & anchor tie downs. Once these have all been removed the cover comes off via clips. No worries these will not break. Pretty easy to pop off. Oh and the plastic cargo latch cover that's held by pop rivets will have to be removed also to remove the wheel well cover. You'll see it when you peel all this back and follow the curve if the cover.
(32.9 KB, 20 views)
(37.5 KB, 19 views)
(27.2 KB, 18 views)
View Public Profile
Send a private message to rxonmymind
Find More Posts by rxonmymind
All times are GMT -6. The time now is
-- DIY Mobile Audio
-- Mobile Skin
DIYMA.com - Car Audio Forum & 12 volt Community Board
Powered by vBulletin®
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
vBulletin Security provided by
vBSecurity v2.2.2 (Pro)
vBulletin Mods & Addons
Copyright © 2017 DragonByte Technologies Ltd.
Ad Management by
Back to top