Car Audio Forum
Car Audio Classifieds
Upgrade Your Account
Car Audio | DiyMobileAudio.com | Car Stereo Forum
EC3 Connectors and other comparisons
View Single Post
DIYMA Been here long time
Thanked 10 Times in 8 Posts
Re: EC3 Connectors and other comparisons
Still rocking a big-ass bag of XT60's I bought off eBay, like I mentioned on this thread in 2014. Same bag, amazingly! Not sure of their performance relative to Deans (which I used on my R/C cars in the past), but the XT60's with their protected terminals are safer to disconnect without fear of a short, if the system is live.
Truly, anything is better than the cheapo spade or bullet connectors of a typical install. I've also had good success with the XT60 used in power-ground setups, since they hold plenty of current and are polarity-proof, as well as short-proof. I use them to get a quick disconnect on my MS-8, as well as a micro-amp that needs ~12 gauge power.
Special thanks to all of the industry experts that share their knowledge here on the forum
2015 Durango R/T,
Build almost complete
MS-8, Massive NX4 pair, Massive N3, ID X6x9, Wavecor center, Alpine SPX Pro tweeters, Sundown SD3 10's
2017 Colorado just starting
View Public Profile
Send a private message to fourthmeal
Find More Posts by fourthmeal
All times are GMT -6. The time now is
-- DIY Mobile Audio
-- Mobile Skin
DIYMA.com - Car Audio Forum & 12 volt Community Board
Powered by vBulletin®
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
vBulletin Security provided by
vBSecurity v2.2.2 (Pro)
vBulletin Mods & Addons
Copyright © 2017 DragonByte Technologies Ltd.
Ad Management by
Back to top