I figured I would start a progress thread for my custom stereo project. Little info:

Car:
-2010 Fusion Sport FWD w/Sony 12 Speaker Stereo (no navigation)

Goal:
-To fill in the freq curve gaps the stock stereo misses
-Bring the stage up in front of the driver
-Clean/Simple install to resemble a factory appearance

Equipment:
Front
-Alpine F1 SPX-Z18T 3-way X-overs
-Alpine F1 [Tweeter]
-Bohlender Graebener Neo8-PDR Planar Transducer (Parts-Express.com:Bohlender Graebener Neo8-PDR Planar Transducer | neo8pdr planar tweeter ribbon tweeter planar transducer) [Mid-range]
-Tang Band W5-1138SM 5-1/4" Neodymium Subwoofer (Parts-Express.com:Tang Band W5-1138SM 5-1/4" Neodymium Subwoofer | subwoofer 5-1/4" subwoofer neodynium subwoofer tangband tb speakers tangband-22008) [Midbass]

Rear
-No Rear Fill

Subwoofer
-IDQ12D4

Amplifier
-US Acoustics 2150 2x150 @ 4ohm RMS [Front Stage]
-US Acoustics 2075 1x240 @ 4ohm RMS [Sub] (I realize the sub w/present a 2ohm load in parallel, if I run into issues I will swap out the sub for the IDQ12D2)

HU
-Alpine CDA-9833 3way Crossover/Time Correction/EQ


Installation Basics:
-Alpine F1 Tweeter in stock location
-The Planar Mid-Range is going to be molded into the A-Pillar
-Midbass will be install in the stock front door midbass location
-Doors will be sound deadened
-Subwoofer will be installed in a cylinder shaped enclosure in the spare tire well sized so a full 18" Sport wheel/tire (spare) and be placed over top of the box as a speaker grill.
-Trunk floor will be raised 4" to account for the added full spare height, along with speaker volume requirements.
-Amps to be installed under raised floor
-Access hole to be cut in stock carpet floor cover to expose the full spare w/sub inside
-Stock subs to be removed.