Change the color of your Hifonics logo...

[NeverEnuffBass]

First you must gut the amp. Be careful not to strip any of the small screws as Hifonics likes to use a generous amount of thread lock.

http://i106.photobucket.com/albums/m254/NeverEnuffBass/Hifonicscolorchange1.jpg

Remove the little heat sinks (blue bars) and take the srews holding the main board out. Remove the sides as well (small torx head) Pull the board out being careful not to break any of the transistors because they like to stick. I stacked all the guts so I would remember how they go in.

You will be left with the cover piece and a smaller circut board attached, those are the LED's. Remove it and cut the harness leaving a little wire attached to the board (in case you decide to go back to blue)

http://i106.photobucket.com/albums/m254/NeverEnuffBass/Hifonicscolorchange3.jpg

Attach your LED strip just under the Hifonics logo, LEDs pointing up. Solder the harness you cut to the pos. + neg on the led strip.

http://i106.photobucket.com/albums/m254/NeverEnuffBass/Hifonicscolorchange4.jpg
http://i106.photobucket.com/albums/m254/NeverEnuffBass/hifonicscolorchange7.jpg
http://i106.photobucket.com/albums/m254/NeverEnuffBass/Hifonicssolder.jpg

Put the amp back together and try it out.

http://i106.photobucket.com/albums/m254/NeverEnuffBass/Hifonicscolorchange6.jpg

[atl530i]

Here are a couple of the newer Zeus series amps I did 2 months ago. I installed these into a Baja 30 Outlaw.

http://www.e34post.com/misc/DSC01292.jpg

[phil]

THAT is clean. any more pics?

[cheesehead]

Pretty Slick! Nice Job!:)