joey_kev
03-31-2006, 03:59 AM
hi all,
I got another car and this time I'm doing the installation myself..
system is as signature
first off: sounddeadening of the spare wheel section (will the floor later when my dynamat arrive)
http://img.photobucket.com/albums/v496/joey_kev/photo3.jpg
fibreglassing:
http://img.photobucket.com/albums/v496/joey_kev/photo13.jpg
amp rack:
http://img.photobucket.com/albums/v496/joey_kev/picture001.jpg
how it looks like in the boot:
http://img.photobucket.com/albums/v496/joey_kev/picture005.jpg
now here I need opinion:
which is the best place for the subs:
this one (sub on each side):
http://img.photobucket.com/albums/v496/joey_kev/photo003.jpg
or this:
http://img.photobucket.com/albums/v496/joey_kev/picture006.jpg
I like the 1st one because it doesn't take too much space. Should I fire them to each other? or should I angle them and fire to the back seat?
The 2nd one probaby the best for SQ application (as I have read here) but a little problem is as you see the sample sub box sit overlap the amp racks. I can try minimise the depth so it doesn't sit overlap the amp racks and go for the width but it can only do around 1.09 cb ft. which is too small for 2 x12" aliantes
what do you guys think?
I got another car and this time I'm doing the installation myself..
system is as signature
first off: sounddeadening of the spare wheel section (will the floor later when my dynamat arrive)
http://img.photobucket.com/albums/v496/joey_kev/photo3.jpg
fibreglassing:
http://img.photobucket.com/albums/v496/joey_kev/photo13.jpg
amp rack:
http://img.photobucket.com/albums/v496/joey_kev/picture001.jpg
how it looks like in the boot:
http://img.photobucket.com/albums/v496/joey_kev/picture005.jpg
now here I need opinion:
which is the best place for the subs:
this one (sub on each side):
http://img.photobucket.com/albums/v496/joey_kev/photo003.jpg
or this:
http://img.photobucket.com/albums/v496/joey_kev/picture006.jpg
I like the 1st one because it doesn't take too much space. Should I fire them to each other? or should I angle them and fire to the back seat?
The 2nd one probaby the best for SQ application (as I have read here) but a little problem is as you see the sample sub box sit overlap the amp racks. I can try minimise the depth so it doesn't sit overlap the amp racks and go for the width but it can only do around 1.09 cb ft. which is too small for 2 x12" aliantes
what do you guys think?
