00 silverado install

[rukkuzz]

I would first like to thank everyone here at diyma for all the insight I’ve gained from lurking around for the past few months. My install is very minimal compared to a lot of the projects here, but I wanted to share my build with the people who unknowingly helped me along.

Goal: Baby steps to SQ …… I couldn’t afford to go “all out at once” on my quest for a great sounding system, so I had to work on the project in steps throughout the past 8 months. As the saga continues, and it will, the gear I don’t like will be moved on to the wife’s car. hehehe!

Gear:
Head: Panasonic CQ-C3403U.
The rear aux input and price were the main reasons.

Ft stage: Goldwood GW-S650/4 6-1/2" with factory tweets.
Amp: Hifonics Txi 6008
I plan to move up in the world here so don’t flame me to bad. Remember, baby steps.
Rear fill: None
Sub stage: 2 Dayton RSS265HO-4 10" in 1.25 cuft sealed
Amp: Kicker zx1000.1
Step 1. Dampening the ft doors. 1 roll of RAAMmat. I have 3 layers on the inside of the outer panel and 2 layers on both sides of the inner.
Before

Let the fun begin!!
In progress.

The big holes covered.



ensolite.

[rukkuzz]

Step 2 the goldwoods were a huge improvement over the stockers



The baffles

[rukkuzz]

The floor and back wall.
Step 3: Dampening the floor and back wall. 1 roll of RAAMmat. Could have used more.
Gutted:

Laying more mat

[rukkuzz]

Step 4: Sub stage.
My new HOs!!!

[rukkuzz]

The box.
My caveman circle cutter.

[rukkuzz]

Covered and done!!





Hopfully in a few months I will have an upgrade or two.

[PUREAUDIO]

comming out really nice