Poor man's 3" front stage [Archive] - DIY Mobile Audio - Now with Violent Bass Air!!

PDA

View Full Version : Poor man's 3" front stage


erickoh
08-06-2006, 09:32 AM
Wanting to see how it would be like to have a 3" driver on-dash, I set out to experiment by cannibalizing my beloved PC sound system's satellite speakers.

They are the pretty well-regarded klipsch GMX satellites, opening them up reveals that the 4-ohm 3" driver is connected directly, wheareas the tweeter has a 3.3uf capacitor connected, a 1st order high pass at 12khz i believe

Doesnt matter, I tore off the little crossover board and ran them active from my pioneer p880rs. The pods fit rather okay on my dash, and I must say they do sound pretty decent and helped raise the soundstage higher than previously. Another interesting initial observation is that I never bothered with the timing alignment function before, but now that the midrange is on-dash, the soundstage was a little muddy, but after tweaking the TA I am able to get back the focused soundstage again..

for now, my crossover settings are
tweets hipass: 10Khz, slope 12db, phase inverted
mids lowpass: 5khz, slope 12db, phase normal
mids hipass: 250hz, slope 12db, phase normal
bass (seas p18rnx) lowpass: 125hz, slope 12db, phase inverted

AJinFLA
08-06-2006, 09:59 AM
That's rather amusing because I used them for the same thing in my old company van.
Try dumping the standard "midbass" for an Aura NS3 and highpass the standard tweeter @ around 14k for some cheap thrills LOL.

cheers,

AJ

coffee_junkee
08-07-2006, 09:52 AM
Nice! I just installed some DIY pods on my dash using the Xtant XIS2.4 concentric 4" drivers. Very smooth, even in a tiny enclosure.

I'm with AJ on the NS3's, they are very nice little mids and for the price, can't be touched.