Just got my Honda Fit , gonna do it up real purdy like and have some fun.
System will be:
Alpine double din with optical out (X008)
2 minidsp 2x4HDs optical input
2 Stevins audio HLCDS
2 Stevins audio 8"
2 Beyma 10g40s (or Stevins audio 10s have to wait till there available to check its parameters)
1 Focal FPS 4160
2 focal FPS 3200
1 JLHD 1200/1 (eventually will be another focal amp)
1 18" B&C subwoofer
Its a 2012 , has 6700 miles, super clean and fresh for a sick build.
Been wanting one for a while when looking for the ultimate SQ Car layout.
My goals are for it to image in both front seats.
I'm going to re-work the dash and cut the horns into the upper firewall right under the windshield. I'm also going to Build a custom a pillar that allows 8" midrange to be mounted in the dash. The location for the 8" had a PLD just over 6". Where The horns will be I measure a PLD at just 4".
I'm going to do a subtub in the spare tire well for the 18" sub. And make it so I can run it either sealed/ported/IB. I'm going to make a port/vent that I can put a plug into, and make a plug on bottom of Car that can be opened to vent out to atmosphere when I want to go IB.
The 10s will be in the footwells cut into the floor/firewall area and fiberglass enclosure that runs down the underside of the car and be sealed and have about/at least 1cu ft of airspace each
The amps will be mounted on a custom anorak that follows the back seat to its top, and will be floating so that I still have a trunk that is useable.
I am installing a high output internally regulated alternator. (270A)
There will also be a second battery on a custom bracket in the engine bay.
Feel free to chat, definitely intrested in any ideas for the build.