Alpine CDA-9853 Mmats Pro 5.0 Comps,Diamond D6 amps..

[lust4sound]

I have a fully functioning Alpine CDA9853 for sale. I will post pics later.

Awesome mid level deck for anyone looking to run a true active 3 way system with full tuning capability right from the deck.

T/A in .05 increments all the way up to 9 MS of delay, variable crossover points and slopes, flat 6/12/18/24DB slopes, rear channels are bandpassable, this gives you true control for midbass , allows fine tuning of top and bottom frequencies..

It is missing the remote and trim ring, I see trim rings in abundance on Ebay for $5 to $9.00 shipped..

I am asking $100 shipped anywhere in the CONUS..

I actually used this deck with an active 2 way XO off the front channels, this gave me full control of a 4 way active system sans ability to delay the tweets, I set front delays to give me optimal vocals, nicely centered, rears where delayed for optimal midbass impact (3 way front stage)

I simply found a way to mount the tweets to compensate for the fact that they were delayed according to the mid/vocal tune.. I simply aimed them in ways that made up for the lack of independent control of T/A..

The end result is a soundstage that is very wide, dash height, blends well, and with the tweeters setup in a funky configuration, I managed to get them to blend (1 on 1 off axis)

Perfect HU with good signal quality for a true 3 way active, add an additional 2 way active to the front channels, then you can run a 4 way system.. Just need to be creative with your tweets.. The end reult was spectacular and worth the effort.. The only reason I am selling is because I have the DRZ9255 on it's way!!

Look for other ads for Diamond Audio D6 amps (1200.1 and 300.4, both mint)
comp speakers by Mmats Pro Audio Pro 5.0 (5.25 midbass/midrange driver with large format treated textile tweeters and 12DB Linkwitz passive XOs. XO point is 3500HZ...) Awesome drivers made in Germany, good build quality, very detailed sound, tweeters are very bold and play remarkable detail well down into the 2.5 KHZ range..

If I can find the grills for the 5.25s I'll include them, if not, I have the grills for the 6.5s in good condition. The comps are perfect, no suspension sag and the tweeters are near indestructible ( I own 3 pair, I am embarrassed to admit that 1 pair were accidentally hooked up to the wrong channels of my 2 way active,they saw 200HZ to 3.5KHZ with 150 watts rms for appox 5 minutes at moderate volume, they survived the ordeal.. Although they are still functioning perfect, those are not the ones I am including in this sale I promise!) The tweets I am including are from my test bench, never been installed in a system, never saw more than 40 watts rms (tweeters will handle 100 watts rms all day, comp set rated at 100 watts rms, midbass/midrange will easily handle 200 watts rms if played from 200HZ and above) If using them from 80HZ and above, will easily handle 100 watts rms..

The Mmats were also part of my front stage, being replaced by L8, L4, L1V2s.. Thats the only reason I am selling them..

$400 plus shipping for the D6s
$150 plus shipping for the Mmats Pro 5.0s. These are definitely worth a listen, Mmats is a low key company that sell nothing but quality gear, these are precision German made drivers.