FS: RF Amp, ID Mids, Alpine 7998, Stinger Cap, misc

[fit_tuner]

Hey guys,

After sorting through my garage and trying to clean up some stuff, i found some things that i won't have any use for anymore. These parts have been taken care of, and some of the socal guys have seen my parts on my green camry before i got rid of it as well as vouch for me if needed. All prices are OBO





Rockford Fosgate 501BD. Mono amp
500x1 @ 2ohm
250x1 @ 4ohm
Includes end caps
-looking for $120 shipped obo





Next i got three ID CX62 mids. 2 were cleaned/reconed by ID before i put them in my car. Another has a puncture in the cone, and missing the phase plug, but performance is not affected (good for a spare in case something happens)
- Looking for $175 shipped obo for all 3.



I have a 1 farad stinger cap with digital read out. Blue LED read out and blue LEDs on the top that light up/do some pattern when something changes. It is silver/chrome and it shows that it's been used. The stinger writing/logo show some chipping.
-Looking for $50 shipped obo



I have about 2 lengths of 14-15 ft of red 4g wire, a 2 ft of silver 4g wire, RCAs, fuse holder, a LOT of fuses, and distro blocks, and 8g wire in red and silver. Basically i have enough for 2 amps, i'll also throw in whatever's left of my roll of 14 g speaker wire, and knu koncepts battery terminals (not the konfused ones). Distro blocks are 1 4g to 2 8g
wire is rf and knu, fuse holder/distro bucks are rf, rcas are rf, i have 5 sets of rcas, will include all if you need them
-Looking for $110 obo shipped for the whole lot


I also have a custom amp rack made, for my camry, but will work for almost any car. Built by James Bang.
-Looking for $20 picked up. I won't ship it.





Last is my beloved alpine cda-7998. There is one scratch on the screen, but it's not that noticeable once the unit is on. Motor works fine and face moves perfectly. Buttons all have wording/pictures on them, some older units have those disappear with age. Includes wiring harness and remote. I hate to give it up, but i just dont have use for it right now.
-Price is $300 shipped.

link to album when my 7998 was installed
http://s100.photobucket.com/albums/m...ne%20CDA-7998/

edit: Pix are up

[fit_tuner]

bump, all prices r obo

[BassBrat]

How much speaker wire you got there?

[fit_tuner]

not sure how much wire i got there, when i have free time later tonight, i'll go unroll it and measure it.

[fit_tuner]

sorry, havent had much time to sit and measure. Took a look at it, and i would say ~25-35 ft or so. If you need an exact length, i'll try to find some time this weekend.

if anyone cares, the 7998 is made in japan, which is news to me as well.

[Audisport44]

Sent PM