DIYMobileAudio.com Car Stereo Forum banner

What amps are you using ?

252K views 1K replies 801 participants last post by  rob3980 
#1 ·
Just as the topic says...

What are you using in your systems ?
 
#278 · (Edited)
old set up, just pulled:

Diamond Audio D6 600.4 & 1500.1 (mono block was ran at 2 ohm) not too bad.

new: either Audison LRx (blue and silver models) 900.1 (2) and a 250.2 or an Audison LRx 5.1k

own not in use... all listed up top there, Xtant 603e, PPI PCX-1250, Phoenix Gold Titanium 475Ti (also known as the 500.4), also have a non working Infinity Beta Digital two channel. also laying on my floor is a Focal FP 1.800 i'm trying to sell.
 
#291 ·
My Current and probably last:
PPI 2075AM
PPI 4100AM
PPI ProMos-425

Not using (selling)
2 pieces Orion 222SX
 
#298 ·
currently in the truck I have the Memphis Belle 16-MCH1300 (5 channel) running 6" midbass in factory door locations L & R, 6" midrange and 1" tweeter in kick pannels and 1" dome tweeters in the dash L & R. And a Memphis 16-MCA3004 (4 channel) running only 6" coaxials in factory rear door locations. But I was actualy thinking today about re-designing my front stage, and adding a center channel. Going compleatly active and adding a second 8" sud, but puting them in the kick pannels to free up the cargo area.

sitting on MTX 91002, (2) 3404, and about to pick up a small kicker 4 ch. I might put in dad's corvette.
 
#299 ·
Current install using
Genesis Dual Mono on Front Mids (Dyn MW170)
Genesis 4 Channel, Special edition with no internal crossovers on front Mid range and tweeter (Dyn MW140 and Dyn Esotar)
Genesis Mini Block for Sub Duties (Focal 27KX)


In the cupboard
Soundstream 705s
Soundstream 604
Becker Energy 600:)
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top