Robert_R

Hi Robert, i talked to you a few weeks ago about a dyn/zapco setup and need some help. I have a dyn 360 unit i want to go fully active with and will have 2 jl 8w7s for subs all controlled by an alpine w505 and h701 processor. Amps will be as follows:

dynaudio tweets and 3" mids - zapco ref 1000.4
dynaudio midbass 8" - 750.2
jl 8"x2 - 750.2

The problem is i want to run everything in stereo at 4 ohms for the dyns, and the tweets will receive 100 watts at 4ohms b/c they are 4ohm drivers as are the midbasses, but the 3" softdomes are 8ohm drivers? What will i do with this problem to keep them at a level to balance with the rest of the system and not hurt the amp? Thanks, Aaron