Can anyone confirm the length of the JAD900.5? On their website it says 14.75", on Sonic Electronix it says 12 8/10 (which is 12 4/5???). That's not alot different but I'm trying to see if this will go under the seat of a Jeep wrangler.
I’m pretty sure you can bridge it. I have one I’ve had for over a year still in the box. I’m going to bridge it to run some 6.5s. I was going to use it until I found a Kenwood excelon 900-5. The Kenwood has a lot stronger sub channel.
Upgraded to an arc 1100.5 and gave my 900.5 to my brother.
We installed it in his car today and could not, for the life of me, figure out how to bridge it.
Used this image in the manual, set the switch to "bridge" and would only get audio out of the left side. Switching it to "2ch" gave us audio out of both sides, but both the front and rear gains were active, corresponding to left and right side..and without any rcas plugged into the rear input
Is the manual wiring method for bridging wrong? Am I overlooking something?