DiyMobileAudio.com Car Stereo Forum banner
arc audio 1200.6
1-6 of 6 Results
  1. System Design: Help Me Choose Equipment For My Car
    Any members here have good experience with a custom box builder they could recommend? I'm interested in as custom box that would fit under the bench seat of a 2018 sprinter. I want to use a single 10in woofer. Leaning toward the JL Audio10W6v3-D4 , but open to suggestions or other options...
  2. Technical & Advanced Car Audio Discussion
    After too many experiments over an extended period of time, my system finally sounds like the musicians are on the hood. So I wanted to pass along a cheat sheet in case it helps someone in the future. All this information is probably available in other places but, either I didn’t understand...
  3. System Design: Help Me Choose Equipment For My Car
    I'm finishing up getting the remainder of my new set up together but have switched up a few things in the past week so down to my last decision, keep my existing JL HD750/1 amp(powering one 10W6v3) or run the sub off bridged channels 5&6 off an Arc XDi 1200.6. I originally purchased the Arc...
  4. Technical & Advanced Car Audio Discussion
    I just installed a set of Focal K2 Power 165 KRX3 in my LX 470. They are being powered off of two channels of my Arc Audio 1200.6 xDI. I didn’t know until last night that the Focal K2 Power 165 KRX3 can drop to an impedance of below 2 ohms unless they are bi-amped. So far the 1200.6 xDI has...
  5. Technical & Advanced Car Audio Discussion
    After 2 months of installing, I finally got a chance to listen to my system and it sounds great! My question is where do I measure the RCA voltage (before or after the MS8)? Since my MS8 is mounted under my passenger seat it was easier to measure it at the amps. According to my Steve Meade...
  6. General Car Audio Discussion
    I am almost finished with my install and wanted to see if anyone had a tuning "Cheat Sheet" on the JBL MS8? I am going full 7.1 surround sound with 2 Arc Audio 1200.6. 6 x 150w each amp (or I am running them in 4 x 150w & 1 x 600w each) 4" Two Way Components in the dash - Amp#1 Channels 1 & 2...
1-6 of 6 Results
Top