DiyMobileAudio.com Car Stereo Forum banner
high level input
1-4 of 4 Results
  1. System Design: Help Me Choose Equipment For My Car
    Hi, Gear: Subwoofer : Rockford Fosgate R2 Ultra Shallow 10-Inch 4 Ohm DVC Subwoofer Amp : Rockford Fosgate R2-250X1 Prime Truck: 2017 Nissan Frontier Pro 4X w/stock Rockford Fosgate head unit and speakers. Be gentle on me here, I know I made a stupid mistake. I'm just trying to figure out...
  2. General Car Audio Discussion
    Did some googling/DIYMA searches and couldn’t find much on this. Knowing that an amp’s speaker wires require a thicker AWG because of the higher current, if you’re just sending that signal to the high-level inputs of an amplifier (or in my case a DSP) instead of the speakers, don’t these inputs...
  3. General Car Audio Discussion
    Factory head unit in 2007 Camry. I have a new set of Kicker speakers to replace my rear speakers. I have a 12" Fosgate powered sub, and a 4 channel Fosgate amp that I'm going to bridge and power the new Kickers. I have a high level to low level (RCA) converter (don't know for sure if I need it)...
  4. Technical & Advanced Car Audio Discussion
    My 03 C230's factory Bose amp has 8 channels. Front tweeters, front woofers, rear woofers, center fill, and sub. The processor can take in 4 channels. I am also ditching the center fill. Obviously I should use the front tweeters and woofers, but I am worried about losing bass if I leave out the...
1-4 of 4 Results
Top