DiyMobileAudio.com Car Stereo Forum banner

jbl c608gti mkii

  1. Upgrading midbass in component set (JBL 608CGTI mid in RE Triple X6.5 C set)?

    General Car Audio Discussion
    Looking to upgrade my midbass in my 2010 MBZ E350. I currently have the RE Triple X 6.5C component set, but I want stronger midbass. It is powered by a RF Punch getting 180 watts per channel into 2ohms. I picked up a set of JBL C608GTI's since they had the best reviews for mibass. The RE...
  2. need help building custom 6.5" speaker mounts and baffles

    Fabrication, Tools & Tricks of the trade
    I am going to try and install my 6.5" JBL C608GTI MKII's this spring break and I need some help building a speaker bracket/mount out of MDF so I can mount them in my doors. I'm going to be putting these in a 2002 Pontiac Grand Am SE; it has 4x6" sock mounting holes, 1-2" from the mounting hole...
  3. 3500Hz fourth-order Linkwitz-Riley compatible tweeters

    Technical & Advanced Car Audio Discussion
    I might be getting some JBL C608GTI MKII mids and the crossover that goes with it, but I would have to get the tweeters separate. My question is are there any other tweeters fully compatible with this set's crossover (3500Hz fourth-order Linkwitz-Riley) and what are they? I know where I can get...
  4. Alternative to JBL C608GTI MKII component set. Need midrange!!!

    System Design: Help Me Choose Equipment For My Car
    I've heard very good things about this set, but also that it lacks midrange and sound reproduction in some areas. From what I've heard they have amazing midbass and will rattle the **** out my doors, but what I really need is midrange and slightly cheaper if possible. I would listen and compare...
  5. How much sound deadener do I need? 2002 Pontiac Grand Am SE

    System Design: Help Me Choose Equipment For My Car
    How many square feet of CLD sound deadener should I get to do the front doors and trunk of my 2002 Pontiac Grand Am SE? I have a couple of Memphis Power Reference 10's in a dual sealed ProBox in my trunk so I don't need a lot there, but I want very little rattle up front since I am putting in a...
  6. Active or passive set up help!

    System Design: Help Me Choose Equipment For My Car
    I need some help deciding on my set up for my JBL C608GTI MKII comp set. It will will have the passive crossover so I can run it passive but I would prefer to go active if I can figure it all out and get what I need. I need to know how to do this and what I will need for this, a wiring diagram...
  7. Amp advice for JBL C608GTI MKII set! 500x2 RMS @ 4ohms. Good SQ, decent efficiency.

    System Design: Help Me Choose Equipment For My Car
    I could use some advice on a good 2-channel amp pushing about 500x2 RMS @ 4ohms. I'm going to be driving a JBL C608GTI MKII component set. I have a Pioneer DXT-736BT HU. I want good SQ for mids/highs, and decent efficiency (SQ is slightly more important tho). I have plenty of space so that's not...
Top