DiyMobileAudio.com Car Stereo Forum banner

loc

  1. New Member Introduction
    Hey I'm having an issue with my loc unit it is a brand new kicker and all of my amp connections are good but when I turn the car on and everything is powered up all is well until I touch the gain knob on my amp. The subwoofer 15 inch vega starts to hum very loudly constant tone. I tried hooking...
  2. Technical & Advanced Car Audio Discussion
    I really need help. First of all everything works so it’s wired correctly. 2007 Camry, stock radio w/o JBL. I have a 4 channel Pioneer amp installed using a PAC Audio 4 channel line out converter (triple checked it is wired correctly). Amp takes a 6v line level input, when I measure the...
  3. General Car Audio Discussion
    I'm working on my 2017 Nissan Armada with Stock Amp and stock Bose speaker I just want to add and LOC to add a powered SUB to get more bass. My question is can I just tap into speaker wires with LOC instead of cutting or splicing them to keep speakers running on stock amp or do I need to cut and...
  4. System Design: Help Me Choose Equipment For My Car
    Hey I have a 2018 Toyota Camry XSE 4cyl non- JBL I'd like to upgrade with a budget of 2k CAD including installation, I mostly listen to hip-hop, rap, r&b, and dance-hall. I want greater sound quality, can you guys help me out? I will be keep the factory head-unit, and it will be taken to a shop...
  5. New Member Introduction
    Hi I am very new to this forum so I’m not sure if this thread is in the right place but anyway... I have just bought a 2009 VW GOLF GT and am trying to swap the subwoofer from my old car into my golf. In my old car I was using an aftermarket stereo so I could connect the sub via the rca outputs...
  6. General Car Audio Discussion
    I'm looking to hook up all four door speakers to my 5-Channel amp. (Alpine PDR-475). Should I get a 4-Channel Line output converter? I am planning on using my factory head unit. If so, any recommendations? Thanks.
  7. Build Logs & Project Install Gallery
    The skinny: • Truck: 2013 1500 Express Regular Cab Short Box 2WD • Head Unit: Stock uConnect 3.0 • Mids and Highs: Stock (possible upgrade later) • Amp: Kicker CX1200.1 (to be purchased next week) • Sub: 12" Eclipse Aluminum Cone (discontinued) • Line Out (LOC): AudioControl LC2i • Wiring: 4...
  8. General Car Audio Discussion
    Hello all, I'm trying to power my front stage components (Alpine SPS-600c with 1" tweeters) with an Alpine MRV-T420 that my brother let me have. I have an alpine Powerpack connected to the HU which is an Alpine CDE-121 which has this preamp output disclaimer... "Installation Note: This...
  9. Car Audio Classifieds
    Product Brand & Model: AudioControl LC6i Condition of all items: Used Total Price: : $110 Shipping Terms: : UPS ground or local meetup in DFW area Pictures: - Unless you are a Upgraded member, or your last 10 iTrader feedbacks are positive, you must post a picture of the exact item...
  10. Technical & Advanced Car Audio Discussion
    This is my setup: -Audiocontrol LC6 LOC -5 Channel Amplifier -Passive Crossovers wired to mid/tweeter components (front) -6x9 Speakers (rear) -Subwoofer (not pictured) Audiocontrol LC6 wired to the Amp: Rear stock speaker wires were tapped and are wired to my LC6 (input signal). RCA...
  11. General Car Audio Discussion
    My HU only has one set of RCA Outputs (which are for the rears). I will be utilizing those rear outputs for channels 3 (Rear Side Panel), 4 (Rear Side Panel) and 5 (Sub) on a 5 channel amp via Y connectors. I want to install a LOC so I can make use of the amp's channels 1 and 2 (Front/Dash). The...
Top