Search Results for ‘ported box’

Hi everyone, This is my first post here so I'd like to start off by saying nice to meet you all. I have had a sealed enclosure in my ute for a good 6 months now. I went sealed as I thought I was very constricted for size having only gone off forum research from others previously taking on the...

I am building a box for an Image Dynamics ID12 D4. My current system has a great top end down to the woofers- nice and punchy all around... but I want to add low "rumbly" frequencies. I have an amp that matches my sub's RMS, and had a 1.7 cu ft box that sounded great but doesn't fit in the trunk...

Port placement questions? SQ installation I am putting two AudioFrog GB10D2 at 4 ohms in a divided enclosure. The inside dimension of each side of the trapezoidal enclosure is roughly 22"T x 22"W and 8" Bottom and 4" Top. Outside dimension is 23.5"T x 46.25" W and 9.5" Bottom and 5.5" Top...

Hey guys, so i bought a 12W6v2 used recently and it came with a ported 12" JL basswedge box, i thought it would sound half decent because it was a JL box.. but was i wrong, it was a one note wonder, and everything else was just sloppy and not as loud, at first i suspected the sub wasn't my...

I have a powerbass xs 12dv.1 that is currently in a sealed box but i'm wanting to put it into a ported. I have the spec sheet and the recommended box sizes with port tuning. My question is, can i just go off of what the spec sheet says and just make a box that is say for example 3 cuft tuned to...

I have an 04 Grand Cherokee and I've been playing around with the audio for a while, but I'm not quite sure what will sound best. My System: 3 way Alpine 6x9's in front doors Stock rear door speakers 4-way Jensen 760 peak running the four door speakers Two 12" Kicker L5's in a sealed box wired...