DIYMobileAudio.com Car Stereo Forum banner
1 - 9 of 9 Posts

· Registered
Joined
·
601 Posts
Discussion Starter · #1 ·
This is my 2000 C3500 I've owned since 2001. Way overdue for a new system. I will also be doing a little "freshen up" So far I've recovered the headliner and visors (darker than stock) replaced the carpet, also went darker than stock, new grill, all new headlights/taillights ,parking lenses, hid's hi and lo beam, replaced every other bulb interior/exterior with led bulbs, and replace the "3 door" ashtray/power plug unit with a "single door" unit

Stinger Heigh10-optical out
Bit10D Full DA
Audison AV5.1kHD Full DA
Dynaudio Esotec 242
Rear fill-Hertz K130
(2) 13TW5-4
OFC Wiring/distribution blocks-Knuconceptz

The CLD deadening was done in 2001. I replaced some peeling "Dynamat Original"


IMG_8067
by Jon Polo, on Flickr

IMG_8059 by Jon Polo, on Flickr

IMG_7812 by Jon Polo, on Flickr

IMG_7813 (1) by Jon Polo, on Flickr

IMG_7813 by Jon Polo, on Flickr

IMG_7814 by Jon Polo, on Flickr

IMG_8063 by Jon Polo, on Flickr

IMG_8075 by Jon Polo, on Flickr


IMG_7907 (1)
by Jon Polo, on Flickr

IMG_8017 by Jon Polo, on Flickr
 

· Registered
Joined
·
601 Posts
Discussion Starter · #2 ·

· Registered
Joined
·
601 Posts
Discussion Starter · #4 ·
These door pods were my first fiberglass project I ever did. I had the black and flame theme throughout my truck. They are still holding up after 21 years. The rears will be reused and the fronts will become garage wall art as the front door panels will be returned to stock

IMG_8064 by Jon Polo, on Flickr

IMG_8065 by Jon Polo, on Flickr

IMG_8066 by Jon Polo, on Flickr

IMG_8086 by Jon Polo, on Flickr

IMG_8088 by Jon Polo, on Flickr

IMG_8094 by Jon Polo, on Flickr

IMG_8095 (1) by Jon Polo, on Flickr
 

· Registered
Joined
·
601 Posts
Discussion Starter · #5 ·
The Heigh10 tray was bonded to the dash insert with 3M Plastic repair and the gaps filled with flat ABS sheet, body worked with Rage Goldbody filler, sprayed with high build primer, wet sanded in the kitchen sink to 400g (only when the wife was not home) spot putty, primered again, wet sanded to 600g, texture coated with light layer of truck bed liner, sprayed with SEM Charcoal, and Medium Grey

IMG_8096 by Jon Polo, on Flickr

IMG_8097 by Jon Polo, on Flickr

IMG_8221 by Jon Polo, on Flickr

IMG_8229 by Jon Polo, on Flickr

IMG_8251 by Jon Polo, on Flickr

IMG_8257 by Jon Polo, on Flickr

IMG_8281 by Jon Polo, on Flickr
 

· Registered
Joined
·
601 Posts
Discussion Starter · #7 ·
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top