DiyMobileAudio.com Car Stereo Forum banner

1 - 4 of 4 Posts

·
Banned
Joined
·
887 Posts
Discussion Starter #1
With some help from thedavel, We tackled my co-workers car this weekend. Simple enclosure int he trunk, amp, and front components.


Dayton 1" tweets

Dayton 6.5"s

MTX RTL 12"

NVX NVPA4 amp

The amp was installed under the steering wheel signal sensing off the stock HU for now. My co-working is still deciding which aftermarket HU to buy.


First picture is of the front door removed. I had to run new speaker wire in to the door. Best way to do that is to remove the door and use the stock molex plug and wire loom.

Second picture is soldering extension wires to the amps signal sensing wires. I used Cat5 wire in this instance. It had 4 pairs of wires which is exactly what I needed.

Third Picture is of the front of the enclosure with the sub installed.

4th picture is of the rear of the enclosure. All seams were bondo glassed on the inside.

Final picture is of the sub enclosure installed with the beauty panels.
 

Attachments

·
Registered
Joined
·
2,214 Posts
Pretty sure my crossover is bigger. LOL

Dayton makes some impressive speakers for unbelievable prices. I replaced a blown Klipsch driver with a Dayton and cant believe how much better it sounds. Replaced a Boston SPG555 sub with Dayton HO 12 and again its louder, clearer and deeper. Don't know how they do it at the prices of their drivers but they do.
 
1 - 4 of 4 Posts
Top