6.5 or 6x9 HAT Imagines in rear door? MS-8 Logic7

584 Views 2 Replies 3 Participants Last post by t3sn4f2, Dec 7, 2014

vinnny

Discussion Starter · Dec 7, 2014

I am finally down to my last few decisions on my system build. I have decided to get three HAT Legatia L3SE for the dash locations and a pair of L6SE for the front doors. This is for an MS-8 Logic7 setup in a crew cab Ram.

I already own a pair of both HAT Imagine 6.5's and 6x9's which I will try in the rear doors. Should I use the 6.5 or 6x9? I'll be sending 100watts, same as the front doors and dash. It is my understanding that I'll get more mid bass with the 6x9, but is it marginal? Or is it better to go with the 6.5 mounted component with the tweeter and woofer in the 6x9 hole?

Save

1 - 1 of 3 Posts

autokraftgt

· #2 · Dec 7, 2014

being a crew cab owner as well...I do not run rear fill and am happy without it.
However, if I did, I would be going after a small amount a ambiance and that's it.
The 6.5 would be my choice out of your two options.

Save

1 - 1 of 3 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month