DiyMobileAudio.com Car Stereo Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
139 Posts
Discussion Starter · #1 ·
I have a treo tsx 10.22 and very little space ( 95 camaro ). Anyways I wanna run it in a slot ported box. This is what the documentation says

Sealed .8 cu ft F3=44 Hz or vented 1.25 cf net, 12sq in vent, 18-1/8 in long, f3=30.4 Hz
I sat down with a calculator and figured everything out and then found the RE box tool and did it again just to make sure. Anyways after that I was looking around and everywhere I look it says I need my slot to be at least 1.5 inches wide. MY design is for 1x12 ( 12sq inches ) Will it work or sound like crap?
 

·
Registered
Joined
·
139 Posts
Discussion Starter · #5 ·
Good 'ol WinISD pro for this one, bro.
Try to keep your vent air speed below 60ft/sec. at the RMS maximum wattage you are going to bother to push to the sub.


Something to remember about a Camaro is that you have WICKED cabin gain. I had a 97 T/A, and its the same. Basically what I'm saying is that a slot ported sub will be very bloated on the bottom end. If you EQ this bloat out, it will rock, but if you can't EQ stuff like that out, you're better off sealed.
Should I tune for a higher freq like maybe 40hz? Also Im thinking of using a round port since it would be a lot easier to fit in the box without the tiny slot.

Any thoughts?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top