DiyMobileAudio.com Car Stereo Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
87 Posts
Discussion Starter · #1 ·
I want to add a JL Cleansweep to an 08 Suburban w/Bose and Navigation. I'm adding new door speakers (front comps and rear co-ax's) and 2 10's in the cargo area. I'll have 2 different amps driving the speakers/subs. My question is do I tap the speaker wires to feed the Cleansweep BEFORE the Bose amp, or AFTER the Bose amp. I have a local guy telling me I need to tap after the amp, but it seems to make more sense to me that I would want to tap before the amp? Any help is appreciated.
 

·
Registered
Joined
·
984 Posts
You DON'T need a Cleansweep in that particular vehicle if it has the Bose system. The Head Unit's outputs are differential-balanced, full-range and non-equalized (flat signals) with full fader/balance functionality. As long as you use amps with differential-balanced inputs, you should be able to grab the Bose amp's input wires, solder some RCA's to them and that's about it. E-mail me at <myusername>@jlaudio.com and I can send you the wire colors you will need to grab.

Best regards,

Manville Smith
JL Audio, Inc.
 

·
Registered
Joined
·
87 Posts
Discussion Starter · #3 ·
Manville,

I fired you off an e-mail.
 

·
Registered
Joined
·
87 Posts
Discussion Starter · #5 ·
Manville,

The email couldn't go through for some reason, I sent you a PM.
 
1 - 7 of 7 Posts
Top