DiyMobileAudio.com Car Stereo Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 · (Edited)
2006 Hyundai Sonata
Kenwood DMX905s

Hyundai provides two 12v sockets in the center console.

Land vehicle Car Steering wheel Center console Vehicle


I'd like to remove one (or both) sockets, then use that real estate to service the two USB jacks that feed a Kenwood DMX905s. I think this'd make for a clean, ergonomic install. Problem is, I don't know if such a doodad exists; eg.: "USB Pass-thru That Replaces the Standard Automotive 12v Socket".

I've google'd variations on the phrasing above, but I come up empty.

Any suggestions?
 

·
Premium Member
2006 Hyundai Sonata V6
Joined
·
688 Posts
I have the same car. Got one of these. It was bigger than the hole left by the plug, had to use a Dremel to remove some plastic. I'm fine with it, but would try a different one if I did it again. But there are many similar items, which might fit better. Works fine with Android Auto / phone connection on Stinger HU. I could have made it straighter, but I got it as tight as I felt comfortable with, and was good enough for me.


304896
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top