DiyMobileAudio.com Car Stereo Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
The boat is an 09 Larson LX1750 and is 17.5ft long
The amp will be mounted in a dry area

There are a total of 12 speakers:
2 sets of MB Quarts tower speaker in Boss- 350 and 60 enclosures
2 MB Quart 116's 60 RMS
2 MB Quart 130's 60 RMS
2 MB Quart 160's 70 RMS

4 Kickers KM6000 6-1/2 hull speakers
2 factory speakers 6-1/2 hull speakers
All are marine speakers
Marine Jensen MSR3007 head unit

Any advice would be most appreciated.

Thank you!
 

·
Registered
Joined
·
4,210 Posts
do you have any subs? or plan to have any? that's a lot of speakers for that space, but I'm all about overkill so I say bring it on!

where are the speakers located? I'd be tempted to use a pair of four channel samps for the interior and a large 2 channel for the tower speakers, but to do this, you need zone control. the gensen might actually have this, but I don't know. you can run two speakers per amp channel and control them, if they are in the same general area.
 
1 - 2 of 2 Posts
Top