DiyMobileAudio.com Car Stereo Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
73 Posts
Discussion Starter #1
I am installing a pair of morel piccolo and a pair of Morel Supreme SCW636 6". I also have a PG Xenon X200.4 and a X200.2. I was going to use the 2 channel to run the component but someone told me to use the X200.4 and bi-amp each piece.
The Accuset MX-22.2 said 280 watts. Will it handle close to 500 watts and is this a good idea. Does anyone know?
 

·
Registered
Joined
·
115 Posts
By biamping you increase your tuning abitlity, but it does nothing else. If you want to spend some time tuning, this is the way to go. How much power do those put out, 100 watts/ch? You can probably get more power out of them if you bridge the 4ch into a 2ch, but you also are liable to lose a little bit of SQ with the gain. I'm actually in a similar situation with a supremo 6 2w and TRU amps. John at TRU told me I would probably be better off going with the 2 ch to power the fronts.
 
1 - 3 of 3 Posts
Top