Fitting them flat on the boot floor would be easiest and put a trim panel over the top to look nice and protect them.
Or attached to the rear seat backs?
I used to have a Lupo and replaced rear seat base cushions with an amp rack, but I didn’t use them so was ok to remove them.
Other options could be passenger front foot well and build it up higher.
As it’s a 3 door the rear 3/4 panels either side of the rear seats could be OK. Take off the panels have a look
Hope this helps!
Sent from my iPhone using Tapatalk
Or attached to the rear seat backs?
I used to have a Lupo and replaced rear seat base cushions with an amp rack, but I didn’t use them so was ok to remove them.
Other options could be passenger front foot well and build it up higher.
As it’s a 3 door the rear 3/4 panels either side of the rear seats could be OK. Take off the panels have a look
Hope this helps!
Sent from my iPhone using Tapatalk
