DiyMobileAudio.com Car Stereo Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
46 Posts
Discussion Starter #1
I pre-ordered this amp last night for my 3-way active front stage:

https://adcaraudio.com/store/product/adk1800-6-pre-order/

It will be powering these six speakers:

8" Mid:
https://www.parts-express.com/dayton-audio-rs225-4-8-reference-woofer-4-ohm--295-376

4" Full range:
https://www.parts-express.com/dayton-audio-rs100-4-4-reference-full-range-driver-4-ohm--295-378

1" Tweeter:
https://www.crutchfield.com/S-mSuc93iFvpl/p_500PS110TW/Alpine-SPS-110TW.html

Controlled by the Audio Dynamics ADDSP68 I also pre-ordered:
https://adcaraudio.com/store/product/addsp68/

Should be a pretty stout (see: loud) front stage, yeah?

I am taking my time with my build and don't have a problem with the component release dates. I just happened to come across the AD 6 channel amp the last night as I was about to pull the trigger on the B2 Audio 1200.6. The AD was a no-brainer upgrade so I didn't hesitate.
 

·
Registered
Joined
·
46 Posts
Discussion Starter #2
Anyone want to confirm whether or not this is a good matching? I think the power put out by the amp will be sufficient while alloing to keep the gain way down and not work too hard. The drivers will have a DSP behind them keeping them safe as well. Any changes IO should make?
 
1 - 3 of 3 Posts
Top