DiyMobileAudio.com Car Stereo Forum banner
1 - 20 of 28 Posts

·
Registered
Joined
·
253 Posts
Discussion Starter · #1 · (Edited)
Product Brand & Model:

1.) Sony XMC2000 Amp
2.) JBL GTQ240 Amp
3.) Coustic 102, 160, (x2) 260 Amps
4.) Rockford Fosgate Punch 500S Amp
5.) Rockford Fosgate OEQ2 Equalizer

Condition of all items:

1.) Cosmetic damage to heatsink, missing speaker output wiring harness, supposedly working but untested

2.) Cosmetic damage throughout, little rust, but still useable, supposed to work but untested

3.) All tested, most rough cosmetically. 160 is pretty clean but the high-level harness is broken out from amp and hardwired.

4.) Tested working. Gain pots are a little roughed up but still usable, missing one screw for endcap, high-level input included but cut short, remote bass eq knob also included with wire but the module has been cracked. Otherwise fair condition

5.) Nice shape, only a little dust and a few scratches on the glass used to show the clipping indicators. Button used to switch input between RCA's and Balanced Input is a little sticky but still functional and likely to not be used unless you're building a RF themed system.

Total Price: :

1.) $45 OBO
2.) $40 OBO
3.) $70 OBO (may split up if you wish)
4.) $125 OBO
5.) $125 OBO

Shipping Terms: :

Likely USPS but can use different carrier if preferred. Please PM me with offers. Paypal payment preferred. Please PM me for paypal, email, and other contact information.

Pictures: - Unless you are a Upgraded member, or your last 10 iTrader feedbacks are positive, you must post a picture of the exact item you are selling.

LINK TO PHOTOBUCKET ALBUM FOR ALL PICS BELOW:

1_22_13 Mobile Audi Sale Photos by GibTG | Photobucket

Additional info:

1.) 6x30 WRMS into 4 ohm, 2/3-way built-in crossover w/ select-able frequencies, filtered subwoofer output

2.) 4x60 WRMS into 4ohm, extensive active crossovers with bandpass capability using filtered outputs, signal routing, +4db bass EQ, presumably underated, says "high current" but spec'd at 2 ohm stable

3.) Gain block amps only, +6/12db bass/treble switch and peak indicators on 260's. 2 ohm stable, ranges from 12.5-45 x2 WRMS into 4 ohm, could be a bit underated.

4.) 250x2 WRMS into 2 ohm, adj. high/lowpass

5.) nice simple and economical way to add a parametric (technically a "quasi-parametic) EQ. Octave/10-band. Two parallel rca stereo outputs. can be used with RF balanced input as well. +-12db adustment, defeatable, and also essentially a line driver (9.3 VRMS output)


** DO NOT DELETE ANYTHING BELOW THIS LINE OR THREAD WILL BE DELETED **
------------------------------------------------------------------------------------------

Please be advised, all buyers and sellers are responsible for performing their own due diligence when considering any financial engagement. We recomend that you:

1) Check the iTrader feedback of the person you are dealing with on this site, as well as other car audio forums.
2) Ask for a name address and phone number. Call them and verify their info.
3) Valid e-mail address. Correspond before committing.
4) consider using an escrow service to protect yourself.

DO NOT proceed with a deal until you are completely satisfied with the other party.

DIYMobileAudio & Collova Media Inc. is not responsible for the outcome of any transaction on this site and will not moderate on your behalf.
 
1 - 20 of 28 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top