DiyMobileAudio.com Car Stereo Forum banner

Status
Not open for further replies.
1 - 14 of 14 Posts

·
Registered
Joined
·
920 Posts
Discussion Starter · #1 · (Edited)
Product Brand & Model:
Clarion APX401.4 and DPX1001.2


Condition of all items:
Used, but in good shape. Maybe a small nick here or there, but probably about an 8-9 out of 10 for each.


Total Price: :
$250 firm shipped to the Continental US


Shipping Terms: :
Included to the Continental US via either USPS, FEDEX or UPS

Items will be boxed and wrapped like a donor heart. I pack things the way I would expect them to arrive.

Insurance is extra.


Pictures: - Unless you are a Upgraded member, or your last 10 iTrader feedbacks are positive, you must post a picture of the exact item you are selling.

See below


Additional info:

I bought these amps a while back, and never found a use for them. I'm pretty sure I remember someone saying these were ARC clones, or made by the same builder, or something like that. Regardless, they're nice amps. I've hooked them both up to verify function. Manuals included.

APX401.4
Frequency Response 20Hz ~ 20kHz
Signal Noise Ratio >95db
THD .05% all channels driven
Input Sensitivity Low Level 250mV ~ 2.5V
Input Sensitivity Speaker Level 500mV ~ 5V
Max. Power Output 380w (190 x 2)
Cont. Power Output 200w (50w x4) @.08% THD
2-Ohm Stereo Output 90 x 4 @ .8% THD
Bridged Power 190 x 2 @ .8% THD
Dimensions 2 1/8” H x 8 1/4” W x 12” L
Current Consumption @ Max 46A @ 380 Watts

The built-in crossovers go up to 5500, which makes this amp suitable to drive a set of components actively.

DPX1001.2
Frequency Response 20Hz ~ 20kHz
Signal Noise Ratio >95db
THD .2% all channels driven
Input Sensitivity Low Level 250mV ~ 2.5 V
Input Sensitivity Speaker Level 500mV - 5V
Max. Power Output 500 watts x 2 @1 ohm
Cont. Power Output 150 watts x 2 into 4 ohms @ <1% THD
2-Ohm Stereo Output 300 watts x 2 into 2 ohms @ <1% THD
Bridged Power
1000 watts x 1 into 2 ohms @ <1% THD

Dimensions 2 1/8” H x 8 1/4” W x 14” L
Current Consumption at output @ max power 86A @ 1000 Watts

A pretty stout two channel subwoofer amp. Includes the remote level control.

Manuals for both amps are attached.



** DO NOT DELETE ANYTHING BELOW THIS LINE OR THREAD WILL BE DELETED **
------------------------------------------------------------------------------------------

Please be advised, all buyers and sellers are responsible for performing their own due diligence when considering any financial engagement. We recomend that you:

1) Check the iTrader feedback of the person you are dealing with on this site, as well as other car audio forums.
2) Ask for a name address and phone number. Call them and verify their info.
3) Valid e-mail address. Correspond before committing.
4) consider using an escrow service to protect yourself.

DO NOT proceed with a deal until you are completely satisfied with the other party.

DIYMobileAudio & Collova Media Inc. is not responsible for the outcome of any transaction on this site and will not moderate on your behalf.
 

·
Registered
Joined
·
920 Posts
Discussion Starter · #3 ·
I'd prefer not to split them up. They're a nice matched pair, and being left with one of them does me no good.

No trades at this point.

Thanks!
 

·
Registered
Joined
·
1,015 Posts
Good guy to deal with here. U ever get those MTXs refinished?
 

·
Registered
Joined
·
920 Posts
Discussion Starter · #6 ·
Thanks man!

I was going to, then I figured I'd be tucking them so far away in the jeep that it didn't matter. They're going to be installed where no one will ever see them.
 
1 - 14 of 14 Posts
Status
Not open for further replies.
Top