DIYMobileAudio.com Car Stereo Forum banner
21 - 27 of 27 Posts

· Registered
Joined
·
664 Posts
Discussion Starter · #22 · (Edited)
racerraul said:
2 Alpine MRV-F345 (50x2 tweets & 300x1 L midbass) (50x2 mids & R 300x1 midbass)
1 Alpine MRD-M605 (400x1 4ohm, 600x1 2ohm subs)
< $900

or

2 Diamond Audio D3 400.4 (50x4 mids & highs) (200x2 midbass) 4ohms
1 Diamond Audio D3 400.2 (400x1 subs 4ohm)
<$800 (Lifetime Warranty authorized)

You guys are coming up with some good ideas. However, in order for me to avoid building a false floor in my hatch, (every square inch needs to be saved) I need to keep it to a two amp system. On top of that, one cannot be longer than 14" and the second no longer than 38" so they both fit on the back of my rear seats. The seats are not tall enough (15") to accommodate two amps side-by-side unless they are super small like the Lanzar Opti line or Xetec. Yeah, I know, this last condition is a pain in the @$$. I am sure you guys are fed up with me hamstringing all your best efforts by now. :blush: It would be so easy if I had a real trunk!
 

· Registered
Joined
·
597 Posts
The Alpines will fit...

Put the F345 next to each other (26" total length)
And the M605 is about 8" wide...

All 3 side by side is a total of 34"... looks to me the Alpine will fit with a little creativity...
 

· Registered
Joined
·
664 Posts
Discussion Starter · #24 ·
Finleyville said:
On top of that, one cannot be longer than 14" and the second no longer than 38" so they both fit on the back of my rear seats.
I'm sorry, I misspoke. I meant that the lengths are 14" and 24" for a total of 38". Oops. :rolleyes:
 

· Registered
Joined
·
664 Posts
Discussion Starter · #26 ·
racerraul said:
Ok...

The F345 + M605 side by side would be 13" + 8" = 21" total < 24"
Another F345 would fit in the 14" space... 13" < 14"
Honestly racerraul, I am not always this stupid. :rolleyes: I totally missed that configuration. I have been looking at specs and dimensions over so many amp lines that my brain has become jumbled.

I have found that maybe a F345 (50x4) and a F545 (100x2 + 500x1) may do the job as well. The only thing I am concerned with the above configuration is 100W enough for the Adire extremis or new Seas nextel series? With your solution I have to buy a third amp, but I am more than satisified with 300W to the extremi. Decisions, decisions..... :)
 

· Registered
Joined
·
597 Posts
I was recommending the 3 amp option assuming a 8ohm midbass...

For what it is worth, the F545 birthsheets I have seen have it cranking out 180+ watts per channel @ 14v... so it definitely has grunt ;)
 
21 - 27 of 27 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top