DIYMobileAudio.com Car Stereo Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
180 Posts
Discussion Starter · #1 ·
Hi guys,

currently i am using pioneer p99rs

my crossover settings are

sw lpf 80hz/18db

Rear 6x9 hpf 80hz/18db lpf 8k/18db

Front components jbl c608gti hpf 80hz/18db lpf 8k/18db

Tweeters 5k/24db

are these settings fine ?
 

· Registered
Joined
·
2,210 Posts
You might want to run the rears high passed a bit higher to avoid midbass localization to the rear. Let the sub handle that transition to the front mids.

The front components seem to be set too high. The mid is probably rolling off due to beaming above 3khz. The passive xover for those drivers uses 3.5khz so start there.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top