Car Stereo Forum banner
1 - 1 of 1 Posts

580 Posts
Discussion Starter · #1 ·
I have a couple CVR-10" DV 2ohm subs. They sounded fine but the tinsel line on one of the voice coils is failing. I have to push up on the tinsel by the cone to get the lines to connect. I need to get into them and run new tinsel lines from the coil to the terminals but I'm not sure how. These don't have a dust cap like other subs.

How do I get into these and solder new tinsel lines?

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.