DiyMobileAudio.com Car Stereo Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
63 Posts
Discussion Starter #1
Has anyone used the eclipse SW8010? I picked one up and it should be here tomorrow. I've been doing some research and there isn't a whole lot of info out there.

I am not sure what size enclosure to build for this thing.
I'm thinking I want to go ported (slot).

Anyone that has used or modeled these care to lend some info?
I have 32-1/8 x 11-1/2 x ? Outside dimensions.

This is the sub.
Eclipse SW8010 10" Single 4 ohm 8000 Series Subwoofer
 

·
Premium Member
Joined
·
1,775 Posts
Man, I was going post up a couple links for you. I just recently purchased a set of 88's. In the thread a guy posted up links with great info.
I went to post them, but checked first, gone! The web host was gone or some crap.
I know how hard it is to find info on them. Good luck...
 

·
Registered
Joined
·
63 Posts
Discussion Starter #3
Well, I tried putting this thing in winisd. Didn't do me much good. I must be a dummy. Not too impressed with that program.
 

·
Registered
Joined
·
63 Posts
Discussion Starter #4
Bringing this back up. I still have this thing. Building a center console for my truck and considered using it. From what reading i have some some guys say it should be I'm a smaller enclosure than what eclipse says. Does anyone have any real world experiences?

I only have about 1.15cu ft net.
 
1 - 4 of 4 Posts
Top