Car Stereo Forum banner

Fibreglass lifting on edges of a pillar

1466 Views 5 Replies 5 Participants Last post by  Orion525iT
My dirst attemp at a pillar builds, not cone out too bad but like an Ass i forgot to drill holes through so it would bond better. Now i trimmed the edges of the fibreglass where it was too thick to fit into dash so when i did that it slightly lifts up from the edges of the glass to pillar. How can i get it to bond on the edges so it doesnt come apart? I built it up by stretching t shirt 2 layers of resin then a layer of mat and resin then another kayer of mat and resin .
1 - 1 of 6 Posts
You won't be able to fix this issue. Maybe the simplest solution would be to start over again.

You can take a look how I prepare a-pillar before applying 14 and 15
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.