DiyMobileAudio.com Car Stereo Forum banner
1 - 20 of 23 Posts

·
Registered
Joined
·
280 Posts
Discussion Starter · #1 ·
I recently built a center channel using (1) AirCirc and (1) 15H so I no longer have use for their counterparts.

I accidentally touched the back cup of the AirCirc with a soldering iron so it has a defect. I covered the hole with tape though I feel there is no leak. I tried finding a replacement with no luck. I would like $100 shipped for the tweeter.

Measurements of the tweeter can be seen at the link below. Dave modded the tweeter for me.
http://www.speakerdesign.net/scan_s...00_tweeter.html

The 15H driver was recently tested my Mark at the link below:
http://audioheuristics.org/measurem...3_test_data.htm

I would like to get $175 shipped for the driver.

If anyone has questions please e-mail me with them.

If anyone is interested in purchasing the single drivers to build the center channel I can pass on the center channel design. The center channel will require a pair of the Dayton Reference 7" (8 ohm) drivers to complete the build.

Also, I have a pair of 18H 52 06 13 SD drivers available. They have the 15H motor with an aluminum voice coil former. It's a mix of the standard 18H and 15H drivers. I am open to offers if someone is interested in them.
 

·
Banned
Joined
·
2,534 Posts
these Scan tweets are supposed to be dynamite for car audio , I wish you had a pair of these.

GLWS
 

·
Registered
Joined
·
891 Posts
Bump for a great guy with some fantastic gear... :)
 
1 - 20 of 23 Posts
Top