DiyMobileAudio.com Car Stereo Forum banner

Status
Not open for further replies.
1 - 13 of 13 Posts

·
Premium Member
Joined
·
167 Posts
Discussion Starter #1
The pair was bought from Don at Unexpected Creations. They are in mint condition with speaker adapter for your BMW. Should fit many models but please check to make sure. This was installed in my BMW F10.

350 shipped
 

·
Premium Member
Joined
·
167 Posts
Discussion Starter #4
BUMP! $300 shipped. Updated

Got everything out and ready to ship. Only thing is that there’s solder on the terminals. See pics
 

Attachments

·
Registered
Joined
·
671 Posts
Completely off-topic, but I've always wondered if the reading from a DMM is an accurate way to determine a speakers impedance. It sounds like it is not, since the pictures posted show 7.5ohms and the speakers are listed as being 6ohms in specs. I've had some speakers where the DMM reading matched the impedance spec and others that I wasn't sure (stock speakers with no impedance specs listed anywhere).

What is the difference between the two (reading from DMM and impedance listed in specs)?

Thanks.
 

·
Registered
Joined
·
742 Posts
Re: FS: Jehnert XE200 pair 8” Midwoofers for BMW

Completely off-topic, but I've always wondered if the reading from a DMM is an accurate way to determine a speakers impedance. It sounds like it is not, since the pictures posted show 7.5ohms and the speakers are listed as being 6ohms in specs. I've had some speakers where the DMM reading matched the impedance spec and others that I wasn't sure (stock speakers with no impedance specs listed anywhere).

What is the difference between the two (reading from DMM and impedance listed in specs)?

Thanks.
DC impedance is different than nominal impedance.
 

·
Premium Member
Joined
·
167 Posts
Discussion Starter #9
I checked it online and it says 6ohm.

My DMM is from harbor freight that cost like 3 bucks. I can check it again but I just checked and posted pictures to show that the voice coils aren’t dead or anything like that.

Again, this was bought new from Don at Unexpected Creations
 

·
Registered
Joined
·
671 Posts
I checked it online and it says 6ohm.

My DMM is from harbor freight that cost like 3 bucks. I can check it again but I just checked and posted pictures to show that the voice coils aren’t dead or anything like that.

Again, this was bought new from Don at Unexpected Creations
No need to check again. As @tonyca stated above, the DC impedance is apparently different than the min impedance. I just was never really sure if they were the same or not, so was just curious. :) Now I know that you can't trust the DMM DC impedance. I always assumed it was the same since most speakers I've tested with a DMM did match the impedance stamped on the speaker, but obviously that is not always the case.
 

·
Premium Member
Joined
·
904 Posts
Re: FS: Jehnert XE200 pair 8” Midwoofers for BMW

Cleared some gear out of storage all to fill it up again:confused:

I‘ll take them.
 

·
Premium Member
Joined
·
167 Posts
Discussion Starter #13
Cleared some gear out of storage all to fill it up again<img src="http://www.diymobileaudio.com/forum/images/smilies/confused.gif" border="0" alt="" title="Confused" class="inlineimg" />

I‘ll take them.
I feel yah. Shoot me a text Ben.
 
1 - 13 of 13 Posts
Status
Not open for further replies.
Top