DiyMobileAudio.com Car Stereo Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1,357 Posts
Discussion Starter · #1 ·
OK, I have the following gear. Will post pics soon.

1) Set Morel Dotech 6 components. Mids used for 2 months, very clean, tweets and xovers NIB. When I was removing the original tweeters, I broke one of them, so I swapped them out with unused tweeters. 28mm silk dome, 3200 xover point, 2' VC midbass. $275 shipped lower 48.


2) One DLS Magnesium UP10. soft magnesium cone, 2x4 ohm VC.

Manual at http://www.dls.se/econtent/files/100/manual_ultimatesubs_eng.pdf

Tested, never run. NIB but part of the cardboard was lost, so some packing is DIY. Recommended for 0.53 cf sealed with a single VC, and .67 tuned for 40 ported.

$150 plus actual freight lower 48 (heavy).

3) Pair used MB Quart 6x9 woofers. Sold as mids in a 2-way kit, but used in an Acura as woofers in a low-power system. $60 shipped lower 48. Good condition but used.

4) Pair DLS 6" woofers NIB. Aluminum cone. RW6. $55 shipped lower 48.

5) 2 DLS W308B 8" woofers NIB. $65 the pair plus actual freight. Heavy.
 

·
Registered
Joined
·
3,428 Posts
Bump for some good prices on DLS gear
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top