DiyMobileAudio.com Car Stereo Forum banner
Status
Not open for further replies.
1 - 20 of 29 Posts

·
Registered
Joined
·
705 Posts
Discussion Starter · #1 ·
EQ:
Kenwood KGC-9042 1/2 din 9 band graphic EQ and spectrum analyzer w/ SW crossover and volume control. 3 sets of pre-outs, also has power clip indicator.
$70 shipped.

Subs:
DIYMA Reference 12, NIB. Single 4, 23mm 1 way xmax (70%bl method) - great SQ sub, not so much for SPL/abuse as we all know.
$100 shipped.

15" JBL GT150, 15" subwoofers, $120 shipped. 15mm 1 way xmax, 250w rms, single 4 ohm. Previous owner put some deadening on the baskets to avoid ringing.

Comps:
Powerbass S-6C, BNIB
$40 shipped

Amps:
Coustic 505-DR: 50x2 @ 4, 150x1 @ 4 bridged. Benches 50% higher. Great amp, pure gain block, no xovers. Nice a/b design by Richard Coe. Kinda dirty, scratched up a bit, works great, missing 1 or 2 screws on terminal blocks.
$65 shipped.

Coustic 510-DR: 100x2 @ 4, 300x1 @ 4 bridged. Benches 50% higher. Great amp, pure gain block, no xovers. Nice a/b design by Richard Coe. Pretty clean looking, sounds amazing, missing bottom cover.
$115 shipped.

Xtant X603: 75x2 + 150x1 @ 4 ohm, double that for 2 ohm. Not much to say about this amp, speaks for itself. Nice a/b Pre-Mitek buyout, pretty underrated. Very minimal scratches, missing 2 screws on the front of the cover, works flawlessly.
$150 shipped. On eGay

Alpine MRP-F320: 40x4 + 120x1 @ 4 ohm, bridges the front 4 channels to 100x2 @ 4 ohm rms. Great little amp, pretty good controls. Little scratched up, but works fine.
$60 shipped.

MTX Thunder 564: 70x4 @ 4 ohm rms, double that at 2 ohm, 280x2 bridged. Great condition less a gash in the paint (not the heatsink) on one side about .5 inch by 1 inch-ish. Works flawlessly, had to add a little solder on the Front RCA inputs to secure them, and is not even remotely noticeable. Great crossover abilities and controls.
$100 shipped.




Deals:
Will combine items for deals. The more you buy, the greater discount. Decided case by case.
 

·
Registered
Joined
·
75 Posts
What is the mounting depth on the DIYMA R12? Also, I wasn't aware of any problems with SPL abuse on the R12's. I've tried a few searches, but haven't turned up much. I would really like 2 of them, but may take a gamble on being able to find another one assuming it fits
 

·
Registered
Joined
·
705 Posts
Discussion Starter · #6 ·
There is another guy on here with one for $130 shipped, also brand new.

And the problem with them was that the cones, in an attempt to reduce moving mass, were made relatively thin. It is a helping factor in making them sound incredible but if you push it too hard, like many on ca.com might, especially in a very small sealed box, you can tear a hole in the cone due to pressure.

Now it's not something that happens to everyone by any means, just if you push them beyond their limits.
 

·
Registered
Joined
·
3,428 Posts
$120 each for the JBL 15" I am assuming... ?
 

·
Registered
Joined
·
705 Posts
Discussion Starter · #13 ·
Just finished installing a pair of the PB S-6C components in my brother's car and they really don't sound half bad.
 

·
Registered
Joined
·
705 Posts
Discussion Starter · #19 ·
PRICE UPDATE

EQ:
Kenwood KGC-9042 1/2 din 9 band graphic EQ and spectrum analyzer w/ SW crossover and volume control. 3 sets of pre-outs, also has power clip indicator.
SOLD

Subs:
DIYMA Reference 12, NIB. Single 4, 23mm 1 way xmax (70%bl method) - great SQ sub, not so much for SPL/abuse as we all know.
$100 shipped.

15" JBL GT150, 15" subwoofers, $120 shipped. 15mm 1 way xmax, 250w rms, single 4 ohm. Previous owner put some deadening on the baskets to avoid ringing.

Comps:
Powerbass S-6C, BNIB
SOLD

Amps:
Coustic 505-DR: 50x2 @ 4, 150x1 @ 4 bridged. Benches 50% higher. Great amp, pure gain block, no xovers. Nice a/b design by Richard Coe. Kinda dirty, scratched up a bit, works great, missing 1 or 2 screws on terminal blocks.
$60 shipped.

Coustic 510-DR: 100x2 @ 4, 300x1 @ 4 bridged. Benches 50% higher. Great amp, pure gain block, no xovers. Nice a/b design by Richard Coe. Pretty clean looking, sounds amazing, missing bottom cover.
$105 shipped.

Xtant X603: 75x2 + 150x1 @ 4 ohm, double that for 2 ohm. Not much to say about this amp, speaks for itself. Nice a/b Pre-Mitek buyout, pretty underrated. Very minimal scratches, missing 2 screws on the front of the cover, works flawlessly.
SOLDOn eGay

Alpine MRP-F320: 40x4 + 120x1 @ 4 ohm, bridges the front 4 channels to 100x2 @ 4 ohm rms. Great little amp, pretty good controls. Little scratched up, but works fine.
$60 shipped.

MTX Thunder 564: 70x4 @ 4 ohm rms, double that at 2 ohm, 280x2 bridged. Great condition less a gash in the paint (not the heatsink) on one side about .5 inch by 1 inch-ish. Works flawlessly, had to add a little solder on the Front RCA inputs to secure them, and is not even remotely noticeable. Great crossover abilities and controls.
$90 shipped.




Deals:
Will combine items for deals. The more you buy, the greater discount. Decided case by case.

There we go. Updated/reduced prices in some.
 
1 - 20 of 29 Posts
Status
Not open for further replies.
Top