DIYMobileAudio.com Car Stereo Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hey everyone, I have an interesting situation going on with one of my amplifiers and was hoping I could get some help.

I have a CT sounds 7000.1D that is going into protect mode. As additional information, when measuring the Positive and Negative terminals on the amp with all wires disconnected it reads a steady 14.1 volts. But as soon as I connect the remote wire and the amp actually turns on(with no rca or speaker wires connected) the amp power light is on but the protect light is flashing and the amp reads a fluctuating 9-10 volts. To me this seems like something is going on with the amp but it is an expensive enought amp to where I would like to diagnose and fix if possible.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top