DiyMobileAudio.com Car Stereo Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter #1
I just got a recone kit for an IDQ, and it comes with 4 shims. No instructions came with it can I can't figure out where the shims need to be installed. I look for instructions everywhere I could think of on the net, but no luck. Could anyone point me in the right directions?
 

·
Registered
Joined
·
12,054 Posts
the shims go in the magnet. put em in there so when you install the cone the voice coil hits the shims and not the magnet. once you screw the new cone down, pull the shims out.

*edit; Matt Borgardt used to have a nice vid on youtube, but I cant find it now. if you have problems, PM him.
 
1 - 2 of 2 Posts
Top