DIYMobileAudio.com Car Stereo Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
1,626 Posts
Every time I run the software it tunes the mids and makes an audible frequency (Front Right & Front Left) and lows (Subs and makes an audible frequency) and tunes them.

When it reaches the Rear Right and Rear Left (Highs/Tweeters) it produces no audible frequencies, does not tune, and does not acknowledge they exist.

The tweeters play from the PXA just fine so it's not like there isn't a signal going through them to the tweeters.

The RCA's are going from the "rear" output on the PXA to the rear input on the amp.
The 3 way switch is on. I also pulled the power and flicked the switch to 3 way before I plugged power back in.

I've even switched the RCAs for mids and tweets at the amp for kicks and it started to work on the front left tweeter and then I got an error. I believe it was a wrong setup error.

What's the deal? What am I doing wrong and why won't the software just acknowledge the presence of the tweeters?
I'm bumping this because I'm having a nearly identical issue. Stupid software isn't recognizing any of the speakers.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top