DIYMobileAudio.com Car Stereo Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
381 Posts
Any 12Volt DC fan should work. I've used computers fans before. I didn't run into any turn on pops, but that would depend greatly on the equiptment you use.
To avoid inducing noise into your amp. I would recommend getting power to the fan at a connection point as far from the amp(s) as possible. As you've mentioned, a fuse is always a good safety feature.
To make sure you don't drain your battery when the car is off. I would recommend you tap it into the remote turn on wire, but use a RELAY switch. The current drawn will probably burn out the remote turn on if you don't use a relay.

David
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top