DiyMobileAudio.com Car Stereo Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
36 Posts
I might get flamed for this, but I have a similar setup to you, and I let the Dirac tune handle it all. I set my crossovers based on arbitrary points starting off, then adjusted while playing some music I’m very familiar with until it sounded best to my ears. I downloaded REW but haven’t used it for one second. If Dirac can match the house curve pretty much perfectly, I don’t think I can do any better.

I did a rough (as precise as reasonably possible) time alignment with metric tape measure, then followed this post I found here about nulling that made a lot of sense to me. So I used nulling to fully dial in time alignment, however Dirac also adds delay, so if you’re going to use Dirac, you’re going to have to live with its results, or else you’re just correcting something that’s already trying to be a correction.
 
1 - 1 of 1 Posts
Top