DiyMobileAudio.com Car Stereo Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
I have a 2011 Hyundai Sonata 4dr with Factory Navigation and 7 speaker system (consists of a front 4”, rear/back 6.5” and 8” factory sub). No additional amps.

Replaced factory speakers with the following:
• Front Dash now: 4” Infinity 32.9FC (Freq Rsp. 85hz – 25k)
• Front Door now: 6.5” Infinity 63.9i (Freq Rsp. 45hz – 30k)
• Rear Door now: 6.5” Infinity 63.9i (Freq Rsp. 45hz – 30k)
• Factory 8” factory sub remains

I have been struggling to determine how to setup the basic configuration of this system with my newly installed JBL MS-8. I’ve attempted to contact JBL technical support but they have been of very little help other than to tell me to use the default settings.

Questions:

• Should I run the dash and front door speakers as 2-way or in a 1-way config?
• What are the recommended cross over frequencies and slope based on my setup?
• Lots of echo with the BT phone. Any idea how to correct?
• I have my single 8” (infinite baffle) Factory sub bridged off channels 7 & 8. During the setup, do I set up for two subs?

I tried to make this post as concise as possible and I apologize in advance if I am logging this into the wrong forum. Any help you can provide would be very much appreciated.
 

·
Registered
Joined
·
321 Posts
I posted a reply in the "JBL's MS-8 Processor!" thread over in the SQ section (Not the MS-8 FAQ thread)
 
1 - 2 of 2 Posts
Top