DIYMobileAudio.com Car Stereo Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
4,398 Posts
10K2HVN said:
- Alpine 9855
- Alpine MRV-F545 (rated at 125x4 @ 14.4v - birthsheet shows 170.3x4 @ 14.4v)

wait a second you have a alpine amp that benches at 170x4?? arent those the 300 dollar ones??

how does it "sound" and yes I know its subjective but whats your best fit comparison

and I swear man you guys make me want to try these darn seas mids lol

if nothign else cause they are so cheap
 

· Registered
Joined
·
4,398 Posts
so you liked the switch from the eclipse TO the 9855??

man I swear I must be crazy or something--lol

but my 8454 sounds way better than my 9835? the sound improvement was immediate?

did they improve the internals of the 9855??

I may try that amp though if it benches that high whoa

since I cant seem to find a big 4 ch or another audison 2.500 anywhere

so I can run three way active

thx for the tip
 

· Registered
Joined
·
4,398 Posts
I dont know man it willbe hard to get a CLEAN signal from a 8" driver of any sort

I ran the dls IR8's up to 2500, and they were not that great up high

usable yes, but much better at 63hz to 1000hz IMO

Im sure your bass output will be good


if its anything like the other morel drivers I have heard you will need all that the 2500xxk can produce to get the most out of em

not sure if you did this already

but Id HIGHLY recommend doubling up your matt amount, especially on the actual door panel


the amount of added throw you are going to get from 8" midranges will cause all kinds of hums and rattles in that fellow nissan :)

I give you props for trying something new as most dont do that!!!
 

· Registered
Joined
·
4,398 Posts
yeah I had to do that too lol on the plastic panel

my next venture is door panel pod :)

jsut trying to decode if I want to keep my 7" cdts as midbass 9which they are good at)

or try and fit that monster peerless 9" in there lol
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top